Igmp-Snooping Querier; Igmp-Snooping Query-Interval - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches

1.1.19 igmp-snooping querier

Syntax
igmp-snooping querier
undo igmp-snooping querier
View
VLAN view
Parameters
None
Description
Use the igmp-snooping querier command to enable the IGMP Snooping querier
function.
Use the undo igmp-snooping querier command to disable the IGMP Snooping
querier function.
By default, the IGMP Snooping querier function is disabled.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Examples
# Enable the IGMP Snooping querier function in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping querier

1.1.20 igmp-snooping query-interval

Syntax
igmp-snooping query-interval interval
undo igmp-snooping query-interval
View
VLAN view
Parameters
interval: Interval between IGMP general queries, in units of seconds. The effective
range is 2 to 300.
Chapter 1 IGMP Snooping Configuration Commands
1-18