Display Ospfv - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Use of this command is only available on the ABR that is connected to a stub area.
You have two commands to configure a stub area: stub, defaulted-cost. You need to
use the stub command on routers connected to a stub area to configure the area as
stub.
If multiple OSPFv3 processes are running, use of this command takes effect only for
the current process.
Related commands: stub.
Examples
# Configure Area1 as a stub area, and specify the cost of the default route advertised to
the stub area as 60.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
[Sysname-ospfv3-1-area-0.0.0.1] default-cost 60

3.1.5 display ospfv3

Syntax
display ospfv3 [ process-id ]
View
Any view
Parameters
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
Description
Use the display ospfv3 command to display the brief information of an OSPFv3
process. If no process ID is specified, OSPFv3 brief information about all processes will
be displayed.
Examples
# Display brief information about all OSPFv3 processes.
<Sysname> display ospfv3
Routing Process "OSPFv3 (1)" with ID 0.0.0.0
SPF schedule delay 5 secs, Hold time between SPFs 10 secs
Minimum LSA interval 5 secs, Minimum LSA arrival 1 secs
Number of external LSA 0. These external LSAs' checksum Sum 0x0000
Number of AS-Scoped Unknown LSA 0
Chapter 3 IPv6 OSPFv3 Configuration Commands
3-4