Igmp-Snooping Last-Member-Query-Interval - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
The source-ip source-address option in the command is meaningful only for
IGMP Snooping version 3. If IGMP Snooping version 2 is running, although you
can include source-ip source-address in the command, the simulated host does
not respond to a query message.
If configured in Ethernet interface view, this feature takes effect on the port only if
the port belongs to the specified VLAN.
If configured in port group view, this feature takes effect only on those ports in this
port group that belong to the specified VLAN.
Examples
# Configure Ethernet 2/0/1 as a s6imulated member host in VLAN 2 for multicast
source 1.1.1.1 and multicast group 224.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping host-join 224.1.1.1 source-ip 1.1.1.1
vlan 2

1.1.16 igmp-snooping last-member-query-interval

Syntax
igmp-snooping last-member-query-interval interval
undo igmp-snooping last-member-query-interval
View
VLAN view
Parameters
interval: Interval between IGMP last-member queries, in units of seconds. The effective
range is 1 to 5.
Description
Use the igmp-snooping last-member-query-interval command to configure the
interval between IGMP last-member queries in the VLAN.
Use the undo igmp-snooping last-member-query-interval command to restore the
default setting.
Chapter 1 IGMP Snooping Configuration Commands
1-15