Port Priority Trust Mode Configuration Commands; Display Qos Trust Interface - H3C S7500E Series Command Manual

Command Manual – QoS
H3C S7500E Series Ethernet Switches
Parameters
priority-value: Port priority to be configured. This argument is in the range 0 to 7.
Description
Use the qos priority command to set the port priority for a port.
Use the undo qos priority command to restore the default port priority.
By default, the port priority is 0.
Note that, if a port receives packets without an 802.1q tag, the switch takes the priority
of the receiving port as the 802.1p precedence of the packets and then searches the
dot1p-dp/lp mapping table for the local/drop precedence for the packets according to
the priority of the receiving port.
Examples
# Set the port priority of Ethernet2/0/1 port to 2.
<Sysname> system-view
[Sysname] interface Ethernet 2/0/1
[Sysname-Ethernet2/0/1] qos priority 2

4.3 Port Priority Trust Mode Configuration Commands

4.3.1 display qos trust interface

Syntax
display qos trust interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type: Port type.
interface-number: Port number.
Description
Use the display qos trust interface command to display the port priority trust mode of
a port.
If no port is specified, this command displays the port priority trust modes of all the
ports.
Examples
# Display the port priority trust mode of Ethernet2/0/1 port.
Chapter 4 Priority Mapping Configuration
4-4
Commands