H3C S7500E Series Command Manual page 1470

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – PoE

H3C S7500E Series Ethernet Switches

2 port(s) on,

Table 1-3 Description on the fields of the display poe interface command

Operating Status

9.2 (W) consumed,

Shortened form of a PoE interface

PoE state: enabled/disabled

enable: PoE is enabled.

disable: PoE is disabled.

Power priority of a PoE interface:

critical (highest)

Current power of a PoE interface

Operating state of a PoE interface

off: PoE is disabled.

on: Power is supplied for a PoE interface normally.

power lack: The guaranteed remaining power of the PSE is

not high enough to supply power for a critical PoE interface.

power-deny: The PSE refuses to supply power. The power

required by the powered device (PD) is higher than the

configured power.

power-itself: The external equipment is supplying power for

power-limit: The PSE is supplying a limited power. The power

required by the PD is higher than the configured power and the

PSE still supplies the configured power.

PD power class defined by IEEE

Chapter 1 PoE Configuration Commands

90.8 (W) remaining ---

Chapters

Table of Contents