Display Pim Claimed-Route - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Scope
Uptime
Next BSR message scheduled
at
Candidate RP
Priority
HoldTime
Advertisement Interval
Next advertisement scheduled at

4.1.16 display pim claimed-route

Syntax
display pim claimed-route [ source-address ]
View
Any view
Parameters
source-address: Displays the information of the unicast route to a particular multicast
source. If you do not provide this argument, this command will display the information
about all unicast routes used by PIM.
Description
Use the display pim claimed-route command to view the information of unicast
routes used by PIM.
If an (S, G) is marked SPT, this (S, G) entry uses a unicast route.
Examples
# View the information of all unicast routes used by PIM.
<Sysname> display pim claimed-route
RPF information about: 172.168.0.0
RPF interface: Vlan-interface2, RPF neighbor: 172.168.0.2
Referenced route/mask: 172.168.0.0/24
Field
4-14
Chapter 4 PIM Configuration Commands
Description
Scope of the BSR
Length of time for which this BSR has been up,
in hours:minutes:seconds
Length of time in which the BSR will expire, in
hours:minutes:seconds
Address of the C-RP
Priority of the C-RP
Timeout time of the C-RP
Interval at which the C-RP sends advertisement
messages
Length of time in which the C-RP will send the
next advertisement message, in
hours:minutes:seconds