Info-Center Snmp Channel - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – Information Center

H3C S7500E Series Ethernet Switches

channel-number: Specifies a channel number, in the range 0 to 9.

channel-name: Specifies a channel name, which could be a default name or a

self-defined name. The user needs to specify a channel name first before using it as a

self-defined channel name. For more information, refer to the info-center channel

name command.

Use the info-center monitor channel command to configure the channel to output

system information to the monitor.

Use the undo info-center monitor channel command to restore the default channel

to output system information to the monitor.

By default, output of system information to the monitor is enabled with a default channel

name of monitor and a default channel number of 1.

Note that the info-center monitor channel command takes effect only after the

information center is enabled with the info-center enable command.

# Set to output system information to the monitor through channel 0.

<Sysname> system-view

[Sysname] info-center monitor channel 0

1.1.19 info-center snmp channel

info-center snmp channel { channel-number | channel-name }