Display Pim Join-Prune - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
PIM require generation ID
PIM hello hold interval
PIM assert hold interval
PIM triggered hello delay
PIM J/P interval
PIM J/P hold interval
PIM BSR domain border
Number of routers on network not using
DR priority
Number of routers on network not using
LAN delay
Number of routers on network not using
neighbor tracking

4.1.20 display pim join-prune

Syntax
display pim join-prune mode { sm [ flags flag-value ] | ssm } [ interface
interface-type interface-number | neighbor neighbor-address ] * [ verbose ]
View
Any view
Parameters
mode: Displays the information of join/prune messages to send in the specified PIM
mode. PIM modes include sm and ssm, which represent PIM-SM and PIM-SSM
respectively.
flags flag-value: Displays routing entries containing the specified flag. Values and
meanings of flag-value are as follows:
rpt: Specifies routing entries on the RPT.
spt: Specifies routing entries on the SPT.
wc: Specifies wildcard routing entries.
Field
4-20
Chapter 4 PIM Configuration Commands
Description
Rejection of Hello messages without
Generation_ID (enabled/disabled)
PIM neighbor timeout time
Assert timeout time
Maximum delay of sending hello
messages
Join/prune interval
Join/prune timeout time
BSR administrative scoping status
(enabled/disabled)
Number of routers not using the DR
priority field on the subnet where the
interface resides
Number of routers not using the LAN
delay field on the subnet where the
interface resides
Number of routers not using neighbor
tracking on the subnet where the
interface resides