H3C S7500E Series Command Manual page 747

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
View
VLAN view
Parameters
version-number: IGMP snooping version, in the range of 2 to 3.
Description
Use the igmp-snooping version command to configure the IGMP Snooping version.
Use the undo igmp-snooping version command to restore the default setting.
By default, the IGMP version is 2.
This command can take effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP Snooping in VLAN 2, and set the IGMP Snooping version to version 3.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
1.1.27 last-member-query-interval
Syntax
last-member-query-interval interval
undo last-member-query-interval
View
IGMP-Snooping view
Parameters
interval: Interval between IGMP last-member queries, in units of seconds. The effective
range is 1 to 5.
Description
Use the last-member-query-interval command to configure the interval between
IGMP last-member queries globally.
Use the undo last-member-query-interval command to restore the default setting.
By default, the interval between IGMP last-member queries is 1 second.
Chapter 1 IGMP Snooping Configuration Commands
1-24