Igmp-Snooping Max-Response-Time - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
By default, the IGMP last-member query interval is 1 second.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: last-member-query-interval.
Examples
# Set the interval between IGMP last-member queries to 3 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping last-member-query-interval 3

1.1.17 igmp-snooping max-response-time

Syntax
igmp-snooping max-response-time interval
undo igmp-snooping max-response-time
View
VLAN view
Parameters
interval: Maximum response time to IGMP general queries, in units of seconds. The
effective range is 1 to 25.
Description
Use the igmp-snooping max-response-time command to configure the maximum
response time to IGMP general queries in the VLAN.
Use the undo igmp-snooping max-response-time command to restore the default
setting.
By default, the maximum response time to IGMP general queries is 10 seconds.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: max-response-time, igmp-snooping query-interval.
Examples
# Set the maximum response time to IGMP general queries to 5 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping max-response-time 5
Chapter 1 IGMP Snooping Configuration Commands
1-16