Display Pim Control-Message Counters - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Referenced route type: unicast (direct)
RPF-route selecting rule: preference-preferred
The (S,G) or (*,G) list dependent on this route entry
(172.168.0.12, 227.0.0.1)
Table 4-2 Description on the fields of the display pim claimed-route command
RPF interface:
RPF neighbor:
Referenced route/mask:
Referenced route type:
RPF-route selecting rule:
The (S,G) or (*,G) list dependent on this
route entry

4.1.17 display pim control-message counters

Syntax
display pim control-message counters [ message-type { probe | register |
register-stop } | [ interface interface-type interface-number | message-type { assert |
bsr | crp | graft | graft-ack | hello | join-prune | state-refresh } ] * ]
View
Any view
Parameters
probe: Displays the number of null register messages.
register: Displays the number of register messages.
register-stop: Displays the number of register-stop messages.
interface interface-type interface-number: Displays the number of PIM control
messages on the specified interface.
assert: Displays the number of assert messages.
bsr: Displays the number of Bootstrap messages.
crp: Displays the number of C-RP-Adv messages.
graft: Displays the number of Graft messages.
graft-ack: Displays the number of Graft-ack messages.
hello: Displays the number of Hello messages.
Field
4-15
Chapter 4 PIM Configuration Commands
Description
RPF interface type and number
IP address of the RPF neighbor
Address/mask of the referenced route
Type of the referenced route
Rule of RPF route selection
(S, G) or (*, G) entries using this route