Reset Hwtacacs Statistics - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Note that:
The IP addresses of the primary and secondary authorization servers cannot be
the same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration takes
effect.
You can remove an authorization server only when no active TCP connection for
sending authorization packets is using it.
Related commands: display hwtacacs.
Examples
# Configure the primary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49

1.3.11 reset hwtacacs statistics

Syntax
reset hwtacacs statistics { accounting | all | authentication | authorization } [ slot
slot-number ]
View
User view
Parameters
accounting: Clears HWTACACS accounting statistics.
all: Clears all HWTACACS statistics.
authentication: Clears HWTACACS authentication statistics.
authorization: Clears HWTACACS authorization statistics.
slot slot-number: Clears HWTACACS statistics on the interface card in the specified
slot.
Description
Use the reset hwtacacs statistics command to clear HWTACACS statistics.
Related commands: display hwtacacs.
Examples
# Clear all HWTACACS statistics.
Chapter 1 AAA/RADIUS/HWTACACS
1-69
Configuration Commands