Temperature-Limit - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – System Maintaining and Debugging

H3C S7500E Series Ethernet Switches

Table 3-12 Default working mode of EA LPUs

LSQ1SRPB, LSQ1MPUA

When the SRPU of the S7500E switch is LSQ1SRP1CB, it is recommended not to

modify the default working mode the EA LPUs.

When the SRPU of the S7500E switch is LSQ1SRP2XB, LSQ1SRPB, or

LSQ1MPUA, if an EA LPU is connected to a Layer 2 forwarding network with a large

number of MAC addresses, you can configure the EA LPU to work in the MAC

extension mode.

To make the configured working mode take effect, you need to save the

configuration and restart the switch.

# Configure the working mode of the EA LPU on slot 2 of the S7502E switch as the

MAC extension mode.

<Sysname> system-view

[Sysname] switch-mode bridging slot 2

# Restore the default working mode of the EA LPU on slot 2 of the S7502E switch.

<Sysname> system-view

[Sysname] undo switch-mode slot 2

3.1.24 temperature-limit

temperature-limit slot-number lower-value upper-value

undo temperature-limit slot-number

Chapter 3 Device Management Commands

Current traffic

forwarding mode of the

l2-enhanced or standard

l2-enhanced or

standard-bridging

standard-routing

Default working mode

Table of Contents