Display Snmp-Agent Trap-List - H3C S7500E Series Command Manual

Command Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches
SNMP version running in the system:

1.1.7 display snmp-agent trap-list

Syntax
display snmp-agent trap-list
View
Any view
Parameters
None
Description
Use the display snmp-agent trap-list command to display the modules that can send
the Trap messages and whether their Trap sending is enabled or not. If a module
comprises of multiple sub-modules, then as long as one sub-module has the sending of
Trap messages enabled, the whole module will be displayed as being enabled with the
Trap sending.
Related commands: snmp-agent trap enable.
Examples
# Display the modules that can send the Trap messages and whether their Trap
sending is enabled or not.
<Sysname> display snmp-agent trap-list
bgp trap enable
configuration trap enable
flash trap enable
ospf trap enable
standard trap enable
system trap enable
vrrp trap enable
Enable traps: 7; Disable traps: 0
In the above output, enable indicates that the module is enabled with the Trap sending
whereas disable indicates the Trap sending is disabled. By default, Trap sending is
enabled on all modules that can send Trap messages. Use the snmp-agent trap
enable command to manually configure whether the Trap sending is enabled or not.
Hangzhou, China
SNMPv3
Chapter 1 SNMP Configuration Commands
1-8