Hwtacacs Scheme - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Specifying a source address for the HWTACACS packets to be sent to the server
can avoid the situation where the packets sent back by the HWTACACS server
cannot reach the device as the result of a physical interface failure.
If you configure the command for more than one time, the last configuration takes
effect.
The nas-ip command in HWTACACS scheme view is only for the current
HWTACACS scheme, while the hwtacacs nas-ip command in system view is for
all HWTACACS schemes. However, the nas-ip command in HWTACACS
scheme view overwrites the configuration of the hwtacacs nas-ip command.
Related commands: nas-ip.
Examples
# Set the IP address for the device to use as the source address of the HWTACACS
packets to 129.10.10.1.
<Sysname> system-view
[Sysname] hwtacacs nas-ip 129.10.10.1

1.3.5 hwtacacs scheme

Syntax
hwtacacs scheme hwtacacs-scheme-name
undo hwtacacs scheme hwtacacs-scheme-name
View
System view
Parameters
hwtacacs-scheme-name: HWTACACS scheme name, a case-insensitive string of 1 to
32 characters.
Description
Use the hwtacacs scheme command to create an HWTACACS scheme and enter
HWTACACS scheme view.
Use the undo hwtacacs scheme command to delete an HWTACACS scheme.
By default, no HWTACACS scheme exists.
Examples
# Create an HWTACACS scheme named hwt1 and enter HWTACACS scheme view.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1]
Chapter 1 AAA/RADIUS/HWTACACS
1-64
Configuration Commands