Display Ipv6 Neighbors Count - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
State
T
Age

1.1.7 display ipv6 neighbors count

Syntax
display ipv6 neighbors { { all | dynamic | static } [ slot slot-number ] | interface
interface-type interface-number | vlan vlan-id } count
View
Any view
Parameters
all: Displays the total number of all neighbor entries, including neighbor entries
acquired dynamically and configured statically.
dynamic: Displays the total number of all neighbor entries acquired dynamically.
static: Displays the total number of neighbor entries configured statically.
slot slot-number: Displays the total number of neighbor entries of a specified slot.
interface interface-type interface-number: Displays the total number of neighbor
entries of a specified interface.
vlan vlan-id: Displays the total number of neighbor entries of a specified VLAN whose
ID ranges from 1 to 4094.
Field
State of a neighbor, including:
INCMP: The address is being resolved. The link layer
address of the neighbor is unknown.
REACH: The neighbor is reachable.
STALE: The reachability of the neighbor is unknown. The
device will not verify the reachability any longer unless
data is sent to the neighbor.
DELAY: The reachability of the neighbor is unknown. The
device sends an NS message after a delay.
PROBE: The reachability of the neighbor is unknown.
The device sends an NS message to verify the
reachability of the neighbor.
Type of neighbor information, including static configuration
and dynamic acquisition.
For a static entry, a hyphen "-" is displayed. For a dynamic
entry, the reachable time (in seconds) elapsed is displayed,
and if it is never reachable, "#" is displayed (for a neighbor
acquired dynamically).
Chapter 1 IPv6 Basics Configuration Commands
Description
1-9