H3C S7500E Series Command Manual page 1376

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the display transceiver alarm interface command to display the current alarm
information of a single or all transceivers.
If no error occurs, None is displayed.
Table 3-7
Table 3-7 Description on the fields of display transceiver alarm interface
GBIC/SFP
RX loss of signal
RX power high
RX power low
TX fault
TX bias high
TX bias low
TX power high
TX power low
Temp high
Temp low
Voltage high
Voltage low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port
configuration mismatch
Transceiver type not supported by
port hardware
XFP
RX loss of signal
RX not ready
RX CDR loss of lock
RX power high
shows the alarm information that may occur for the four types of transceivers.
Field
Chapter 3 Device Management Commands
RX signal is lost.
RX power is high.
RX power is low.
TX fault
TX bias current is high.
TX bias current is low.
TX power is high.
TX power is low.
Temperature is high.
Temperature is low.
Voltage is high.
Voltage is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port
configuration.
Transceiver type is not supported on the port.
RX signal is lost.
RX is not ready
RX clock cannot be recovered.
RX power is high.
3-13
Remarks