H3C S7500E Series Command Manual page 764

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Related commands: igmp fast-leave, last-member-query-interval.
Note:
This command takes effect only on Layer 3 interfaces other than VLAN interfaces when
executed in IGMP view.
Examples
# Enable fast leave processing globally.
<Sysname> system-view
[Sysname] igmp
[Sysname-igmp] fast-leave
3.1.6 igmp
Syntax
igmp
undo igmp
View
System view
Parameters
None
Description
Use the igmp command to enter IGMP view.
Use the undo igmp command to remove configurations performed in IGMP view.
IP multicast must be enabled on the device before this command can take effect.
Related commands: igmp enable.
Examples
# Enter IGMP view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] igmp
[Sysname-igmp]
Chapter 3 IGMP Configuration Commands
3-8