H3C S7500E Series Command Manual page 541

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
View
RIPng view
Parameters
route-policy-name: Name of a routing policy, in the range of 1 to 19 characters.
preference: RIPng route priority, in the range of 1 to 255.
Description
Use the preference command to specify the RIPng route priority.
Use the undo preference route-policy command to restore the default.
By default, the priority of a RIPng route is 100.
Using the route-policy keyword can set a priority for routes filtered in by the routing
policy:
If a priority is set in the routing policy, the priority applies to matched routes, and
the priority set by the preference command applies to routes not matched.
If no priority is set in the routing policy, the one set by the preference command
applies to all routes.
Examples
# Set the RIPng route priority to 120.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] preference 120
# Restore the default RIPng route priority.
[Sysname-ripng-100] undo preference
2.1.12 ripng
Syntax
ripng [ process-id ]
undo ripng [ process-id ]
View
System view
Parameters
process-id: RIPng process ID, in the range of 1 to 65535. The default value is 1.
Chapter 2 IPv6 RIPng Configuration
2-11
Commands