Igmp-Snooping General-Query Source-Ip - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
If you do not specify any VLAN in manual port group view, the command will take
effect on all the ports in this group no matter which VLANs these port belong to; if
you specify a VLAN or multiple VLANs, the command will take effect on those
ports in this group that belong to the specified VLAN(s).
Configurations made in aggregation port group view are effective only for the
master port in the group. If you do not specify any VLAN in aggregation port group
view, the command will take effect no matter which VLAN the master port belongs
to; if you specify a VLAN or multiple VLANs, the command will take effect only if
the master port belongs to the specified VLAN(s).
Related commands: fast-leave.
Examples
# Enable the fast leave feature on Ethernet 2/0/1, which belongs to VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping fast-leave vlan 2

1.1.11 igmp-snooping general-query source-ip

Syntax
igmp-snooping general-query source-ip { current-interface | ip-address }
undo igmp-snooping general-query source-ip
View
VLAN view
Parameters
current-interface: Sets the source address of IGMP general queries to the address of
the current VLAN interface. If the current VLAN interface does not have an IP address,
the default IP address 0.0.0.0 will be used as the source IP address of IGMP general
queries.
ip-address: Specifies the source address of IGMP general queries, which can be any
legal IP address.
Description
Use the igmp-snooping general-query source-ip command to configure the source
address of IGMP general queries.
Use the undo igmp-snooping general-query source-ip command to restore the
default configuration.
By default, the source IP address of IGMP general queries is 0.0.0.0.
Chapter 1 IGMP Snooping Configuration Commands
1-10