H3C S7500E Series Command Manual page 959

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname -radius-radius1] retry realtime-accounting 10
1.2.17 retry stop-accounting
Syntax
retry stop-accounting retry-times
undo retry stop-accounting
View
RADIUS scheme view
Parameters
retry-times: Maximum number of stop-accounting request transmission attempts. It
ranges from 10 to 65,535 and defaults to 500.
Description
Use the retry stop-accounting command to set the maximum number of
stop-accounting request transmission attempts.
Use the undo retry stop-accounting command to restore the default.
Suppose that the RADIUS server response timeout period is 3 seconds (set with
the timer response-timeout command), the timeout retransmission attempts is
5 (set with the retry command), and the maximum number of stop-accounting
request transmission attempts is 20 (set with the retry stop-accounting
command). This means that for each stop-accounting request, if the device
receives no response within 3 seconds, it will initiate a new request. If still no
responses are received within 5 renewed requests, the stop-accounting request
is deemed unsuccessful. Then the device will temporarily store the request in the
device and resend a request and repeat the whole process described above.
Only when 20 consecutive attempts fail will the device discard the request.
Related commands: reset stop-accounting-buffer, radius scheme, display
stop-accounting-buffer.
Examples
# Set the maximum number of stop-accounting request transmission attempts to 1,000
for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] retry stop-accounting 1000
Chapter 1 AAA/RADIUS/HWTACACS
1-50
Configuration Commands