Ripng Summary-Address - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Parameters
None
Description
Use the rip split-horizon command to enable the split horizon function.
Use the undo rip split-horizon command to disable the split horizon function.
By default, the split horizon function is enabled.
Note that:
The split horizon function is necessary for preventing routing loops. Therefore, you
are not recommended to disable it.
In special cases, make sure that it is necessary to disable the split horizon function
before doing so.
Note:
If both the poison reverse and split horizon functions are enabled, only the poison
reverse function takes effect.
Examples
Enable the split horizon function on Van-interface100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng split-horizon

2.1.19 ripng summary-address

Syntax
ripng summary-address ipv6-address prefix-length
undo ripng summary-address ipv6-address prefix-length
View
Interface view
Parameters
ipv6-address: Destination IPv6 address prefix of the summary route.
prefix-length: Destination IPv6 address prefix length of the summary route, in the range
0 to 128.
Chapter 2 IPv6 RIPng Configuration
2-16
Commands