H3C S7500E Series Command Manual page 1509

Command Manual – RRPP
H3C S7500E Series Ethernet Switches
If you have specified an RRPP ring ID in the command, the detailed information of the
specified ring in the specified RRPP domain appears. Otherwise, the detailed
information of all the rings in the specified RRPP domain appears.
Examples
# Display the detailed information of ring 1 in RRPP domain 1.
<Sysname> display rrpp verbose domain 1 ring 1
Domain ID
Control VLAN
Hello Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status : Yes
Primary port
Secondary port: GigabitEthernet3/0/2
# Display the detailed information of all the rings in RRPP domain 2.
<Sysname> display rrpp verbose domain 2
Domain ID
Control VLAN
Hello Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status : Yes
Primary port
Secondary port: GigabitEthernet3/0/5
Ring ID
Ring Level
Node Mode
Ring State
Enable Status : No
Common port
Edge port
: 1
: Major 5 Sub 6
: 1 sec Fail Timer : 3
: 1
: 1
: Master
: Complete
Active Status: Yes
: GigabitEthernet3/0/1
: 2
: Major 10 Sub 11
: 1 sec Fail Timer : 3
: 1
: 0
: Master
: Complete
Active Status: Yes
: GigabitEthernet3/0/4
: 2
: 1
: Edge
: -
Active Status: No
: GigabitEthernet3/0/4
: GigabitEthernet3/0/3
1-7
Chapter 1 RRPP Configuration Commands
sec
Port status: UP
Port status: BLOCKED
sec
Port status: UP
Port status: BLOCKED
Port status: -
Port status: -