H3C S7500E Series Command Manual page 1510

Hide thumbs Also See for S7500E Series:
Table of Contents

Advertisement

Command Manual – RRPP
H3C S7500E Series Ethernet Switches
Table 1-3 Description on the fields of the display rrpp verbose command
Domain ID
Control VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Ring State
Enable Status
Active Status
Primary Port
Secondary Port
Common Port
Edge Port
Field
RRPP domain ID
Control VLANs of the RRPP domain, including major control
VLAN and sub control VLAN
Hello Timer value configured in seconds
Fail Timer value configured in seconds
RRPP ring ID
RRPP ring level, with 0 representing primary ring and 1
representing subring
Node mode: master node, transit node, edge node and
assistant edge node
RRPP ring state. This field makes a sense only when the
node mode field is master node. "Complete" appears when
the ring is in health state; "Failed" appears when the ring is
in disconnect sate; and "–" appears in all the other cases.
RRPP ring enable status: Yes indicates enabled and No
indicates disabled
RRPP ring activation status: Yes indicates active and No
indicates inactive
The current ring is active only when the RRPP protocol and
the RRPP ring are enabled simultaneously. Through this
field, you can get to know the enable status of the RRPP
protocol.
The primary port field means the node mode is master node
or transit node. "-" appears when the port is not configured
on the ring or the board to which the port belongs does not
start.
The secondary port field means the node mode is master
node or transit node. "-" appears when the port is not
configured on the ring or the board to which the port belongs
does not start.
The common port field means the node mode is edge node
or assistant edge node. "-" appears when the port is not
configured on the ring or the board to which the port belongs
does not start.
The edge port field means the node mode is edge node or
assistant edge node. "-" appears when the port is not
configured on the ring or the board to which the port belongs
does not start.
Chapter 1 RRPP Configuration Commands
Description
1-8

Advertisement

Table of Contents
loading

Table of Contents