H3C S7500E Series Command Manual page 1167

Command Manual – Port Mirroring
H3C S7500E Series Ethernet Switches
View
System view
Parameters
group-id: Port mirroring group number, in the range of 1 to 4.
rprobe-vlan-id: ID of the VLAN to be configured as the remote mirroring VLAN. Note
that the VLAN must be an existing static VLAN.
Description
Use the mirroring-group remote-probe vlan command to specify a VLAN as the
mirroring VLAN for a remote source port mirroring group or a remote destination port
mirroring group.
Use the undo mirroring-group remote-probe vlan command to remove the remote
mirroring VLAN from a remote source mirroring group or a remote destination mirroring
group.
Note that:
Only remote source port mirroring groups or remote destination port mirroring
groups can have remote mirroring VLANs. A port mirroring group can have only
one remote mirroring VLAN.
To remove a VLAN operating as a remote port mirroring VLAN, you need to
restore it to a normal VLAN first. A remote port mirroring group gets invalid if the
corresponding remote port mirroring VLAN is removed.
You are recommended to use a remote mirroring VLAN for remote mirroring only.
Examples
# Specify VLAN 2 as the remote mirroring VLAN of port mirroring group 1 (assuming
that VLAN 2 already exists).
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 remote-probe vlan 2
1.1.7 mirroring-port
Syntax
[ mirroring-group group-id ] mirroring-port { inbound | outbound | both }
undo [ mirroring-group group-id ] mirroring-port { inbound | outbound | both }
View
Ethernet port view
Chapter 1 Port Mirroring Configuration Commands
1-7