Snmp-Agent Trap Enable - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – SNMP-RMON

H3C S7500E Series Ethernet Switches

<Sysname> system-view

[Sysname] snmp-agent trap enable standard

[Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 params

securityname public

# Enable the device to send SNMP Traps to the device which is in VPN 1 and has an IP

address of 10.1.1.1, using the community name of public.

<Sysname> system-view

[Sysname] snmp-agent trap enable standard

vpn-instance vpn1 params securityname public

1.1.20 snmp-agent trap enable

snmp-agent trap enable [ bgp | configuration | flash | ospf [ process-id ]

warmstart ]* | system | vrrp [ authfailure | newmaster ] ]

undo snmp-agent trap enable [ bgp | configuration | flash | ospf [ process-id ]

warmstart ]* | system | vrrp [ authfailure | newmaster ] ]

bgp: Enables the sending of BGP Trap messages.

configuration: Enables the sending of configuration Trap messages.

flash: Enables the sending of FLASH Trap messages.

ospf [ process-id ] [ ospf-trap-list ]: Enables the sending of OSPF Trap messages. The

parameter process-id is the process ID and spf-trap-list is the Trap packet list.

standard: Enables the sending of standard Trap messages.

authentication: Enables the sending of authentication failure Trap messages in

the event of authentication failure.

coldstart: Sends coldstart Trap messages when the device restarts.

linkdown: Sends linkdown Trap messages when the port is in a linkdown status. It

should be configured globally.

linkup: Sends linkup Trap messages when the port is in a linkup status. It should

be configured globally.

warmstart: Sends warmstart Trap messages when the SNMP restarts.

system: Sends H3C-SYS-MAN-MIB (a private MIB) Trap messages.

Chapter 1 SNMP Configuration Commands

Table of Contents