Display Poe Interface Power - H3C S7500E Series Command Manual

Command Manual – PoE
H3C S7500E Series Ethernet Switches
Field
Detection Status
port(s) on
consumed
Remaining

1.1.5 display poe interface power

Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display poe interface power command to display the power information of a
PoE interface(s).
If no interface is specified, the power information of all PoE interfaces will be displayed.
Examples
# Display the power information of Ethernet 2/0/2.
<Sysname> display poe interface power Ethernet 2/0/2
Interface
Eth2/0/2
# Display the power information of all PoE interfaces.
<Sysname> display poe interface power
Interface
Power detection state of a PoE interface:
disabled: The PoE function is disabled.
searching: The PoE interface is searching for the PD.
delivering-power: The PoE interface is supplying power for
the PD.
fault: There is a fault defined in 802.3af.
test: The PoE interface is under test.
There is a fault other than defined in 802.3af.
pd-disconnect: The PD is disconnected.
Number of PoE interfaces that are supplying power
Power consumed by the current PoE interface
Total remaining power of the system
CurPower PeakPower MaxPower PD Description
(W) (W)
15.0 15.3
CurPower PeakPower
(W) (W)
Chapter 1 PoE Configuration Commands
Description
(W)
15.4 Acess Point on Room 509 for Peter
MaxPower PD Description
(W)
1-8