Procedures
............................................................................................................................................................................................................................................................
Configure a 1P10GSO module
Purpose
Use this procedure to configure a 10GSO module on a select board.
........................................................................................................................................................................................................................
Select Rack xx -> Shelf xx -> Board xx from the tree area as shown in
1
Figure 5-9 Rack xx -> Shelf xx -> Board xx
........................................................................................................................................................................................................................
Select the board to be provisioned from the Provisioned Type drop-down list box. In this
2
case 1P10GSO.
........................................................................................................................................................................................................................
Table 5-1, "Board x parameters" (p. 5-15)
3
Board x parameters.
Table 5-1 Board x parameters
Parameter
Access Identifier
Actual Type
Provisioned Type
Primary state
Automatic In-Service Mode
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
provides description of the Rack x > Shelf x >
Description
Specifies the access identifier of the selected module
Specifies if the board is configured or not
Specifies the type of equipment to be provisioned
Specifies the primary state of the equipment. The values are:
IS
•
OOS
•
Indicates the automatic in-service mode. The values are:
AINS
•
NOWAIT
•
Configure a 1P10GSO module
Figure
5-9.
5 - 1 5