Mac Address Learning Operation; List Of Operation Commands; Checking The Status Of Mac Address Learning; Checking The Mac Address Learning Count - Alaxala AX2200S Series Configuration Manual

16 MAC Address Learning

16.3 MAC address learning operation

16.3.1 List of operation commands

The following table describes the operation commands for MAC address learning.
Table 16-6 List of operation commands
Command name
show mac-address-table
clear mac-address-table

16.3.2 Checking the status of MAC address learning

The show mac-address-table
address learning. Use it to check the MAC addresses registered in the MAC address table,
as well as to check the forwarding destination for frames with the MAC address used as the
destination. Any frames with a destination other than the MAC addresses displayed by this
command are flooded to the entire VLAN.
The show mac-address-table
address learning, static entries, and entries registered by Layer 2 authentication, IGMP
snooping, and MLD snooping.
Figure 16-1 Result of executing the show mac-address-table command
> show mac-address-table
Date 2009/03/16 23:24:47 UTC
Aging time : 300
MAC address
0000.0088.7701
000b.972f.e22b
0000.ef01.34f4
0000.ef01.3d17
000b.9727.ee41
0010.c6ce.e1c6
0012.e284.c703
001b.7887.a492
0100.5e00.00fc
>

16.3.3 Checking the MAC address learning count

The show mac-address-table
can be used to display the number of dynamic entries registered by MAC address learning
for each port, and to check the number of terminals connected per port.
When link aggregation is used, the same value is displayed for all ports in the same
channel group. The displayed value is the number of learned addresses in the channel
group.
Figure 16-2 Result of executing the show mac-address-table command (with the
> show mac-address-table learning-counter
248
Description
Displays information about the MAC address table.
learning-counter
When the
address count for MAC address learning is displayed for each port.
Clears the MAC address table.
operation command displays information about MAC
operation command displays the entries registered by MAC
VLAN Type
2 Dynamic
2 Dot1x
1000 Static
1000 Static
1024 WebAuth
1024 MacAuth
1024 Dynamic
1024 Dynamic
1024 Snoop
operation command (and l
learning-counter parameter specified)
parameter is specified, the learning
Port-list
0/49-50
0/35
0/30
0/30
0/28
0/29
0/49-50
0/49-50
0/49-50
earning-counter parameter)