25.3.4 Configuring multicast router ports
Points to note
When a multicast router is connected within a VLAN for which MLD snooping is set,
specify the settings below for the VLAN interface configuration mode of the
corresponding VLAN. The following shows an example where the multicast router is
connected to the Ethernet interface on port 0/1 within the target VLAN.
Command examples
1.
(config)# interface vlan 2
(config-if)# ipv6 mld snooping mrouter interface fastethernet 0/1
(config-if)# exit
Specifies the multicast router port for the corresponding interface.
Notes
If you set a port number belonging to a port channel interface for a multicast router
port, no operation is performed.
25.3.5 Setting the source IP address of an MLD Query message
Points to note
When using the MLD querier functionality, you must specify the source IP address of
a Query message sent from the Switch. Specify the following settings in VLAN
interface configuration mode for the VLAN for which the MLD querier functionality is
used.
Command examples
1.
(config)# interface vlan 2
(config-if)# ipv6 mld snooping source fe80::1
(config-if)# exit
Specifies the source IP address of the MLD Query message for the target interface
to
fe80::1
Notes
1.
2.
25 Settings and Operation for IGMP Snooping and MLD Snooping
.
This command is applied to the source IP address of the MLD Query
message.
Set an IPv6 link-local address for the source address.
453