Ip Arp Inspection Limit Rate - Alaxala AX3640S Software Manual

25. DHCP Snooping

ip arp inspection limit rate

Sets the maximum ARP packet reception rate (the number of ARP packets that can be received per
second) per Switch when DHCP snooping is enabled on the Switch. ARP packets in excess of this
reception rate are discarded. The actual maximum reception rate is the sum of that set by this
command and that set by the
that can be received is the total number of DHCP packets and ARP packets.
Syntax
To set or change information:
ip arp inspection limit rate <packet/s>
To delete information:
no ip arp inspection limit rate
Input mode
(config)
Parameters
<packet/s>
Sets the number of ARP packets that can be received per second.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
10 to 125 (packets/s)
Default behavior
The reception rate is not restricted.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Values specified by using this command set the upper limit for the number of received
packets, but do not guarantee operation with the specified value.
Related commands
ip dhcp snooping
600
ip dhcp snooping limit rate
command. The number of packets