Spanning-Tree Single Mode - Alaxala AX3640S Software Manual

13. Spanning Tree Protocol

spanning-tree single mode

Sets the operating mode of Single Spanning Tree.
Syntax
To set or change information:
spanning-tree single mode { stp | rapid-stp }
To delete information:
no spanning-tree single mode
Input mode
(config)
Parameters
{ stp | rapid-stp }
Sets the protocol to be used. If the protocol is changed during Spanning Tree operation, the
Spanning Tree Protocol is re-initialized. If
rapid-stp
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
stp
Default behavior
is set for the Single Spanning Tree operating mode.
stp
Impact on communication
If the
spanning-tree single
of the topology is complete.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None
238
is set, rapid Spanning Tree mode is used.
or
rapid-stp
command is set, communications are interrupted until recalculation
is set, Spanning Tree mode is used. If
stp