Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring Dealer Access Numbers
Configuring Dealer Access Numbers
The dealer access numbers indicate from which connections the PBX can be remotely
configured without manual activation. For this purpose, the PC connected to the PBX via an
external ISDN connection must transmit one of the entered dealer access numbers.
Note: If no dealer access number has been configured or the telephone
number transmitted does not correspond with the configured telephone
numbers, the PBX must be activated via an internal telephone using a digit
sequence for remote configuration.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page SERVICE > Remote configuration.
2. In the entry fields Dealer access number 1 to Dealer access number 4 under
Authorization for remote configuration (PPP), enter one external telephone
number along with the local area code in each field (local dialling code). The following
entries are possible:
Up to 20 digits
Digits
Further steps:
– Save your settings before you leave the page.
Switching Dealer Access over the Internet On/Off
You can switch dealer access over the Internet on or off as follows:
• Via the configuration manager
Requirements:
550
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020