Table of Contents
Advertisement
Functions, Uses, Concepts
Baby Call
Baby Call
The baby call function provides a service in which after a configured delay
time after picking up the receiver, a phone number is automatically dialled
to call an internal or external subscriber. This means, no key needs to be
pressed. However, if a phone is dialled manually within the configured delay
time, it has priority. It must be noted that on some phones, the numbers
dialled are not sent immediately when the keys are pressed (often there is
approx. a half second delay).
Note: The baby call function is not available for VoIP phones.
Proceed as follows for configuration:
•
Switching the baby call function on.
– Using the Configuration Manager (page Subscriber (scr.) >
Properties > Settings)
– Using a character string on the internal phone (see chapter Short
Reference > Baby Call)
•
Configuring the baby call function configuration dependent.
– Using the Configuration Manager (page Subscriber (scr.) > Profiles
> ... > Settings)
•
If necessary, configuring special dial tone for baby call.
– Using the Configuration Manager (page Subscriber (scr.) >
Properties > Settings)
•
Configuring delay time for baby call.
– Using the Configuration Manager (page Subscriber (scr.) > All
subscribers)
48
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
