Transferring Without Announcement; Placing External Communication Partner In Waiting Loop - Auerswald COMpact 3000 analog Operating Manual

Transferring without Announcement

Requirements:
– Internal transfer destination
During a call, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Enter the internal telephone number. The following entries are possible:
** and internal telephone number of the individual telephone
use a direct exchange line access, omit the **.)
** and internal telephone number of the line group
direct exchange line access, omit the **.)
3. Wait until you hear the ring tone.
4. Hang up the receiver.
Once the called subscriber accepts the call, he is connected with the external
subscriber.
Note: If the subscriber being called does not accept the call, the call is trans-
ferred back to your telephone 60 seconds later (your telephone rings).If you
do not accept the call within 60 seconds the call will be disconnected. If your
own telephone has become busy in the meantime, the procedure will already
be canceled after the first 60 seconds and the external call will be discon-
nected.

Placing External Communication Partner in Waiting Loop

Requirements:
– Internal transfer destination
If the internal telephone to which you are trying to transfer a call is busy, proceed as described
in the following.
1. Wait.
You will automatically be reconnected with the waiting communication partner.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Telephoning
Transfer
Transferring without Announcement
(If you do not
(If you do not use a
121