Ip Rip Receive Version - Allied Telesis AT-x510-28GTX Command Reference Manual

RIP C
OMMANDS

IP RIP RECEIVE VERSION

ip rip receive version
Overview Use this command to specify the version of RIP packets accepted on an interface
and override the setting of the version command.
Use the no variant of this command to use the setting specified by the
command.
Syntax ip rip receive version {[1][2]}
no ip rip receive version
Default Version 2
Mode Interface Configuration for a VLAN interface.
Usage This command can only be used on VLAN interfaces.
This command applies to a specific VLAN interface and overrides any the version
specified by the
RIP can be run in version 1 or version 2 mode. Version 2 has more features than
version 1; in particular RIP version 2 supports authentication and classless routing.
Once the RIP version is set, RIP packets of that version will be received and sent on
all the RIP-enabled interfaces.
In the following example, the VLAN interface vlan3 is configured to receive both
Example
RIP version 1 and 2 packets:
awplus#
awplus(config)#
awplus(config-if)#
Related version (RIP)
Commands
C613-50102-01 REV C
Parameter Description
1
Specifies acceptance of RIP version 1 packets on the interface.
2
Specifies acceptance of RIP version 2 packets on the interface.
version (RIP)
configure terminal
interface vlan3
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
command.
ip rip receive version 1 2
version (RIP)
834