L2Tp Failover-Resync - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
l2tp failover-resync
Syntax
Release Information
Description
Options
Mode
1168
l2tp failover-resync { failover-protocol | failover-protocol-fallback-to-silent-failover |
silent-failover | disable }
no l2tp failover-resync
Command introduced in JunosE Release 7.3.0.
Configures the global L2TP peer resynchronization method that an L2TP failed endpoint
uses to resynchronize with its peer non-failed endpoint. This setting can be overridden
by a peer resynchronization method that is configured by either an L2TP host profile or
an AAA domain map tunnel configuration. The no version disables peer resynchronization.
The default version restores the default peer resynchronization method,
failover-protocol-fallback-to-silent-failover.
failover-protocol—Specifies the L2TP failover protocol method
failover-protocol-fallback-to-silent-failover—Specifies the L2TP failover protocol
method; however, if the peer does not support this method, the silent failover method
is used; this is the default setting
silent-failover—Specifies the silent failover method
disable—Disables peer resynchronization
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
