L2Tp Failover-Resync - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

l2tp failover-resync

Syntax
Release Information
Description
Options
Mode
1170
l2tp failover-resync { failover-protocol | failover-protocol-fallback-to-silent-failover |
silent-failover | disable }
no l2tp failover-resync
Command introduced in JunosE Release 7.3.0.
Configures the global L2TP peer resynchronization method that an L2TP failed endpoint
uses to resynchronize with its peer non-failed endpoint. This setting can be overridden
by a peer resynchronization method that is configured by either an L2TP host profile or
an AAA domain map tunnel configuration. The no version disables peer resynchronization.
The default version restores the default peer resynchronization method,
failover-protocol-fallback-to-silent-failover.
failover-protocol—Specifies the L2TP failover protocol method
failover-protocol-fallback-to-silent-failover—Specifies the L2TP failover protocol
method; however, if the peer does not support this method, the silent failover method
is used; this is the default setting
silent-failover—Specifies the silent failover method
disable—Disables peer resynchronization
Global Configuration
Copyright © 2010, Juniper Networks, Inc.