L2 Transport Load-Balancing-Circuit Configuration Mode; L2Tp Destination Profile Configuration Mode; L2Tp Destination Profile Host Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

L2 Transport Load-Balancing-Circuit Configuration Mode

L2TP Destination Profile Configuration Mode

L2TP Destination Profile Host Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
In this mode, you can specify a member subinterface for a Martini layer 2 circuit that is
associated with a load-balancing group.
From Global Configuration mode, type mpls l2transport load-balancing-group, specify
a group number and a Martini circuit, and press Enter.
host1(config)#mpls l2transport load-balancing-group 100 mpls-relay 10.1.1.1 30
host1(config-l2transport-load-balancing-circuit)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
member Configure members of a l2transport load-balancing circuit
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can create the destination profile that defines the location of an L2TP
Access Concentrator (LAC) and define the attributes used when an L2TP Network Server
(LNS) communicates with an LAC. The destination is necessary to enable an LAC to
connect to the LNS.
From Global Configuration mode, type l2tp destination profile, the profileName, an
ipAddress, and press Enter.
host1(config)#l2tp destination profile augusta ip address 123.45.76.16
host1(config-l2tp-dest-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
remote Configure L2TP remote parameters
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can set and modify L2TP host profile attributes, such as the proxy Link
Control Protocol (LCP), the local hostname, the local IP address, or the interface profile.
From Global Configuration mode, enter L2TP Destination Profile mode (see above), and
type remote host and a hostName, and press Enter.
host1(config-l2tp-dest-profile)#remote host george
host1(config-l2tp-dest-profile-host)#?
default Set a command to its default(s)
disable Disable L2TP parameter for remote host
do Run an exec mode command (alias command run)
Chapter 2: Command-Line Interface
95