Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3612

•
When modifying an SNMP station, you must specify an IP address plus at least one additional
parameter. For example, the syntax snmp station 1.2.3.4 is not a valid command entry; however,
snmp station 1.2.3.4 v2 is a valid command entry.
•
The default UDP port 162 is commonly used for traps; however, the destination port can be redefined
to accommodate an SNMP station using a nonstandard port. The destination port specified in the
command line must correspond with the UDP destination port configured at the receiving SNMP
station(s).
•
When the SNMP station is enabled the switch will send ICMP echo requests to verify reachability. The
switch transmits traps to the specified IP or IPv6 address immediately after receiving the ICMP echo
response.
Examples
-> snmp station 168.22.2.2 111 username2 v1 disable
-> snmp station 168.151.2.101 "test lab"
-> snmp station 170.1.2.3 username1 enable
-> snmp station 1.1.2.2 v2
-> no snmp station 2.2.2.2
-> snmp station 300::1 enable
-> no snmp station 300::1
Release History
Release 6.1; command was introduced.
Release 6.3.1; ipv6_address parameter added.
Related Commands
show snmp station
MIB Objects
trapStationTable
trapStationIP
trapStationPort
trapStationUser
trapStationProtocol
trapStationRowStatus
alaTrapInetStationTable
alaTrapInetStationIPType
alaTrapInetStationIP
alaTrapInetStationPort
alaTrapInetStationRowStatus
alaTrapInetStationProtocol
alaTrapInetStationUser
page 61-4
Displays the current SNMP station information.
OmniSwitch CLI Reference Guide
SNMP Commands
June 2012