Show Snmp Station - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show snmp station

Displays the current SNMP station status.
show snmp station
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
N/A
Examples
-> show snmp station
ipAddress/udpPort
-------------------------------------------------------------------------------
199.199.100.200/8010
199.199.101.201/111
199.199.102.202/8002
199.199.103.203/8003
199.199.104.204/8004
The following is an example of the output display using IPv6.
-> show snmp station
ipAddress/udpPort
---------------------------------------------------+---------+--------+------
172.21.160.32/4000
172.21.160.12/5000
0300:0000:0000:0000:0211:d8ff:fe47:470b/4001
0300:0000:0000:0000:0211:d8ff:fe47:470c/5001
output definitions
IPAddress
UDP Port
Status
Protocol
User
page 61-6
status protocol user
enable v3 NMSuserV3MD5DES
disable v2 NMSuserV3MD5
enable v1 NMSuserV3SHADES
enable v3 NMSuserV3SHADES
enable v3 NMSuserV3SHA
IP Address of the SNMP management station that replayed the trap.
Note: OmniSwitch stackable and chassis-based switches support both
IP and IPv6 SNMP stations.
UDP port number.
The Enabled/Disabled status of the SNMP management station.
The version of SNMP set for this management station.
The user account name.
status protocol user
enable v3
enable v3
enable v3
enable v2
OmniSwitch CLI Reference Guide
SNMP Commands
abc
user1
user2
abc
June 2012