Snmp Source Ip Preferred - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

SNMP Commands

snmp source ip preferred

Configures the source IP address field of the SNMP client packets.
snmp soure ip preferred {default | no-loopback | ip_address}
no snmp source ip preferred
Syntax Definitions
default
no-loopback
ip_address
Defaults
By default, the setting is set to the default parameter.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
When configuring a specific IP address, that address must already exist on the switch.
•
Use the no form of this command to clear a specific IP address and change the behavior back to
default.
Examples
-> snmp source ip preferred 192.168.10.1
-> snmp source ip preferred no-loopback
-> snmp source ip preferred default
Release History
Release 6.3.4; command was introduced
Release 6.4.3; command was deprecated, use
Related Commands
snmp station
OmniSwitch CLI Reference Guide
The Loopback0 address, if configured, will be used for the source IP
address field. If no Loopback0 is configured, the first IP address on the
switch will be used.
The Loopback0 address should not be used for the source IP address
field and the first available IP address on the switch should be used for
this field.
The IP address to be used in the source IP field.
ip managed-interface.
Adds a new SNMP station; modifies or deletes an existing SNMP sta-
tion.
June 2012 page 61-5