Show Configuration Snapshot - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show configuration snapshot

Displays the switch's current running configuration for all features or for the specified feature(s).
show configuration snapshot [feature_list]
Syntax Definitions
feature_list
snapshot-supported features
802.1q
aaa
aip
all
bgp
bridge
chassis
health
interface
ip
ip-helper
ip-routing
netsec
Defaults
By default, this command shows configuration information for all features.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use this command to view the current configuration for any feature shown in the table.
•
To show a list of features on the switch, use the show configuration snapshot ? syntax.
•
Configurations are listed below the name of each feature.
•
Features with no current configuration show only the name of the feature.
page 60-14
Specify the feature(s) for which you want to display the running config-
uration. List the features separated by a space with no comma.
ipmr
ipms
ipx
ipv6
linkagg
module
ntp
ospf
ospf3
pmm
policy
qos
Configuration File Manager Commands
rdp
rip
ripng
session
slb
snmp
stp
system
vlan
vrrp
webmgt
udld
OmniSwitch CLI Reference Guide June 2012