Chapter 61 Snmp Commands - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

This chapter includes descriptions for Trap Manager and SNMP Agent commands. The commands are
used for configuring SNMP settings on the switch.
•
SNMP station commands can create, modify, or delete an SNMP station. Also included is a show
command for monitoring current SNMP station status.
•
SNMP trap commands configure SNMP trap settings. Traps can be replayed and filtered. Also, test
traps can be generated to verify that individual traps are being correctly handled by the Network
Management Station (NMS). The SNMP trap commands set includes show commands for monitoring
SNMP trap information.
•
SNMP agent commands configure SNMP security levels on the switch. Also includes show commands
for monitoring the current SNMP security status.
MIB information for SNMP Community commands is as follows:
Filename: IETFsnmpCommunity.MIB
Module: IETF SNMP-COMMUNITY.MIB
MIB information for Trap Manager commands is a follows:
Filename AlcatelIND1TrapMgr.MIB
Module: ALCATEL-IND1-TRAP-MGR.MIB
MIB information for SNMP Agent commands is a follows:
Filename: AlcatelIND1SNMPAgent.MIB
Module: ALCATEL-IND1-SNMP-AGENT.MIB
OmniSwitch CLI Reference Guide
61 SNMP Commands
June 2012 page 61-1