Ftp6 - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

File Management Commands

ftp6

Starts an FTPv6 session.
ftp6 {ipv6_address | hostname} [if_name]
Syntax Definitions
ipv6_address
hostname
if_name
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
You must have a valid username and password for the specified host.
•
A console, a telnet or an SSH session can handle only one FTPv6 client session.
•
You can establish upto 9 FTP or FTPv6 sessions from an OmniSwitch (when it acts as FTP Client) and
upto 4 FTP or FTPv6 sessions towards an OmniSwitch (when it acts as FTP Server).
•
If the session is invoked using the server's link-local address, the source interface name must be
provided.
•
After logging in, FTPv6 commands are supported. They are defined in the following table:
ascii
binary
bye
cd
close
delete
dir
get
hash
help
lcd
OmniSwitch CLI Reference Guide
Specifies the IPv6 address of the FTPv6 server.
Specifies the hostname of the FTPv6 server.
The name of the interface used to reach the FTPv6 server, if the target
has been specified using the link-local address.
Set transfer type to ASCII (7-bit).
Set transfer type to binary (8-bit).
Close session gracefully.
Change to a new directory on the remote machine.
Terminate the ftp session.
Delete a file on the remote machine.
Obtain a long listing on the remote machine.
Retrieve a file from the remote machine.
Print the hash symbol (#) for every block of data transferred. (This com-
mand toggles hash enabling and disabling.)
Display list of available FTP commands.
Change to a new directory on the local machine.
June 2012 page 58-47