Putting Standard Isdn End Devices Into Operation - Auerswald COMpact 3000 analog Operating Manual

COMpact 3000 VoIP: The following figure shows the position of the RJ-45 sockets at
the side of the casing, as well as the set up connection to the PC.
Note:
Even if the Ethernet port on the PBX is already connected to the internal
network (LAN), you also need to connect the PC to the internal network. For
more information, contact your system administrator.
To configure the PBX via the Ethernet port, the PC and the PBX have to be
connected to the same network. For the first contact to the PBX, consult the
quick commissioning instructions shipped with the unit.

Putting Standard ISDN End Devices into Operation

Requirements:
– The internal telephone number is configured on the S
1. Connect end devices with a separate power supply to the 230 V mains.
2. Enter the internal telephone number as an MSN for the end device.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Installation and Commissioning
Putting Standard ISDN End Devices into Operation
port in question.
0
Commissioning
77