Configuring A Dial-Up Connection On The Pc - Auerswald COMpact 3000 analog Operating Manual

– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page SERVICE > Remote configuration.
2. Select or clear the Enable dealer access via Internet check box.
Switches remote programming for ARA access on.
Switches remote programming for ARA access off.
Further steps:
– Save your settings before you leave the page.

Configuring a Dial-up Connection on the PC

The PBX supports the transmission of configuration data by remote data transmission (dial-up).
This can take place over an indirect internal or external ISDN connection on a device that is not
only connected to an internal or external S
controller or Auerswald USB device). The PBX must be configured for this purpose accordingly.
A dial-up connection must also have been previously configured on the PC.
Note: The following steps describe how to configure the PC on the operating
system Windows 7. If using another operating system or one with significant
differences to the basic settings, refer to the documentation of your operating
system.
Configuring a Dial-up Connection on Windows 7
Requirements:
– For configuration via the internal S
– For remote configuration via the external S
– Knowledge of the external PIN, the sub-admin PIN or admin PIN
1. Click Start.
2. Click Control Panel.
3. Click Network and Internet.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
0
port: Configured internal CAPI dial-in number
0
Remote Configuration and Alternative Connection Options
Configuring a Dial-up Connection on the PC
port on the PBX but also to a PC (ISDN PC
port: Configured remote switching number
0
Service and Maintenance
551