Table of Contents
Advertisement
40
You want to listen into a Room (Room Monitoring)
Configure Automatic Dialling / Hot Line
b 7 Q 191
your
public
telephone
password
Switch on/off Automatic Dialling / Hot Line
b 7 Q 191
your
public
telephone
password
b 7 Q 190
your
public
telephone
password
T
You can also use the T-Net sequence, you can activate the
„connection without dialling" with
#53#
deactivate with
. If you are using an analog telephone that de/
activates „connection without dialling" by T-Net function key/menu, you
can use this comfortable functionality (see manual of the telephone;
eventually named „direct call"). Instead of the announcement of the
public exchange, you will get an acknowledgement tone.
If you like to listen into a room, e.g to check if your baby sleeps, you can
use the function „Room Monitoring" of the PBX. The internal telephone
has to be configured for this function. The room monitoring can be done
with an internal as well as an external telephone.
Enable the Room Monitoring on an internal Telephone
b
7 Q 68 # d
telephone in the
public
room to be monitored
password
It is not possible to make a call from this telephone.
It is only possible to enable a single telephone for Room Moni-
toring at the same time.
To deactivate Room Monitoring, replace the receiver of the telephone.
n
internal number of the target
telephone
0r
or
Exchange Line Access
Number and external number
of the target telephone
k
or
Short-Code Dial Number
#
#
*53*
#
+ number +
and
You want to listen into a Room (Room Monitoring)
Place the receiver
near the telephone.
#
Switch on Automatic Dialling with entry of an internal
subscriber telephone number as destination
Switch on Automatic Dialling with entry of an external
Switch on Automatic Dialling with entry of a Short-
Switching on Automatic Dialling without Entry of a
Number, because Number is already configured
Switching off Automatic Dialling (Start Dialling within 2 Seconds)
If you are asked to enter a target number when using the T-Net func-
tions, you have to enter the Exchange Line Access Number
nal numbers. On the PBX you are also able to enter Short-Code Dial
Numbers and internal numbers.
N
These settings are configuration dependent.
After the configuration the receiver will be placed near the telephone. A
secret monitoring is not possible.
Start Room Monitoring to be able to listen into the room
number as destination
Code Dial Number as destination
0
for exter-
Advertisement
Table of Contents
