Ending One Of The Two Calls - Auerswald COMpact 5200 Advanced Information

Note:
You can also use this function on analogue phones, where it can be
performed via the T-Net function key/menu (optional, see manual for the
phone).
On ISDN and system phones, this function is performed via an existing
function key or via the menu (optional, see manual for the phone).

Ending One of the Two Calls

When you end a query call and want to continue talking with one of the
communication partners, you can specifically end the call with the other
communication partner separately.
If one of your two communication partners hangs up the receiver, you will
remain connected with the other one.
Alternatively, during a query call, proceed as described in one of the
following steps.
• Press the Flash key or the Query key and dial 1.
The current call is disconnected.
You will then make an one-to-one call with the communication partner
who had previously been on hold.
• Press the Flash key or the Query key and dial 0.
The call in the background will be disconnected.
You will then make an one-to-one call with the communication partner
who had previously been active.
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
Phoning
Query Calls
265