Loopback Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
L I
OOPBACK NTERFACE
To create a virtual loopback interface and/or activate the Loopback Interface Configuration mode, enter
the interface loopback command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface loopback 1
(config-loop 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 2390
crypto map <name> on page 2391
dynamic-dns on page 2393
ip commands begin on page 2395
ipv6 dhcp relay destination <ipv6 address> on page 2432
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2433
rtp quality-monitoring on page 2434
snmp trap on page 2435
snmp trap link-status on page 2436
vrf forwarding <name> on page 2437
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Loopback Interface Command Set

2389